Aqueous Enteric Coating System Case Study

Tablets

Wishing to investigate a new process using a fully formulated enteric coating system, a study was done to evaluate the suitability of a novel semi-continuous coating process for the rapid application of an aqueous enteric coating system as a model functional coating.

Semi-Continuous Coating

Aspirin tablets (325 mg) were used as the coating substrate. The coating was a fully formulated aqueous enteric coating system, Acryl-EZE® (Colorcon Inc.), prepared at a solids concentration of 20%. The coating trial was conducted with a batch size of 3 kg and the final target weight gain (WG) was 12% w/w.

Tablets were automatically fed into a single coating module and automatically discharged at the completion of each coating cycle in a semi-continuous process. 

Coated tablet samples were withdrawn from the process at 5, 6, 8 and 10% applied WG. Enteric performance was evaluated using USP Dissolution Apparatus 1 at 100 RPM. Enteric coated tablets (n = 6) were tested in 0.1N HCl for 2 h and then immediately transferred into phosphate buffer (pH 6.8) for dissolution and drug release testing.

Results

The enteric coated tablets were smooth and glossy and free from any apparent defects. The color uniformity of the tablets was very good — as expected at the higher weight gains sampled for enteric testing. Dissolution testing demonstrated robust enteric coating performance: 5% WG samples exhibited no drug release at pH 1.2, and a release of greater than 90% in 45 minutes in pH 6.8 buffer.

Slight differences in the rate of drug release were observed in the buffer phase depending on the applied coating WG. As expected, a higher WG resulted in a slightly slower release; yet, all samples reached >90% release within 20 minutes. The total coating time to reach 12% WG was 30 minutes. Passing enteric results were achieved in 12.5 minutes of coating at 5% WG, indicating excellent coating uniformity. This early protection and the absence of any visible tablet edge defects indicates low tablet stress in this dynamic process.

Conclusions

The results indicate that the ConsiGma® semi-continuous coating process can achieve uniform application of functional coatings at low weight gains in a very short process time. The ConsiGma® coater would also be ideal for the application of immediate release aesthetic coatings wherein the coating WG needed to achieve color uniformity would be substantially less than needed for enteric protection. Another significant advantage of this coater is that development batches in this unit are effectively completed at commercial scale, expediting transfer to manufacturing. The Acryl-EZE®, fully formulated enteric coating system was found to be well suited for use in this new coating technology. 

capsules with coated pellets

Related technologies

Precision Coating

The GEA PRECISION-COATER is a fluid bed coating technology that is particularly suitable for smaller particles and pellets.

It provides significant improvements in coating performance compared to traditional coating systems.

Receive news from GEA

Stay in touch with GEA innovations and stories by signing up for news from GEA.

Contact us

We are here to help! With just a few details we will be able to respond to your inquiry.