iNTELSTART is designed to work in conjunction with either iNTELFLOW, iNTELCENTER or iNTELPUMP controller.
iNTELSTART will also turn the water off automatically during the wash cycle, eliminating the risk of accidental cooling of hot wash water.
It controls the vacuum pump motor contactors and if using a water ring type vacuum pump a float switch can be installed in the water reservoir. If there is no water present, the pump will not run, thus preventing damage to the pump system.
Run On Time | 1-20 seconds |
Pump Out Time | 1-30 seconds |
Auto Milk Start | Yes / No |
Pump Manager | ADV / STD |
Milk / Wash Delay | 1-60 seconds |
Milk Clear Time | 1-60 seconds |
Injector On Time | 1-120 seconds |
Actuator Cycle Time | 1-120 seconds |
Actuator On Time | 1-30 seconds |
Pump Off Delay | 1-120 seconds |
PHE Start Delay | 0-30 seconds |
PHE Run On Time | 1-120 seconds |
Fluid Level Switch | N/O, N/C |
Fluid Level Shut Down | 1-30 seconds |
Network | Yes, automatic initiation of milk, wash and off modes. |
Operating Voltage | 12-15V DC |
Controller Output | Milk pump contractor 250V, 3 amps max |
Purge Valve Output | 12V DC |
Overload Protection | Yes – sub miniature fuses |
Input Protection | Polarity protected |
Enclosure | 165mmH x 220mm W x 110mmD |
IP Protection | IP55 |
Input Voltage | 240V AC 50/60Hz |
Output | 12V DC output 1 amp |
Enclosure | 88mmH x 68mmW x 59mmD |
Operating Voltage | 12V DC |
Operating Temperature | 0-750C |
Flying Lead | 0.5m |
IP Rating | To IP68 |
Materials | Nylon |
iNTELFLOW is designed to sense the level of milk in the receiving can via a stainless steel float and the milk pump speed is then adjusted accordingly.
iNTELCENTER is designed to control the bulk of the equipment around the receiving can in a modern parlor.
iNTELPUMP is designed to sense the level of milk in the receiving can via a stainless steel float and then cycle the milk pump contactor according to the level.